Reasons And Countermeasures For The Detachment Of Babbitt Alloy On Compressor Main Shaft Tile

Apr 22, 2025 Leave a message

The detachment of Babbitt alloy on the compressor spindle tile is usually caused by the following reasons:
1. Excessive wear: Long term operation and friction can cause wear on the surface of the main shaft bearing, leading to loosening or detachment of the bearing layer.
2. Power imbalance: If there is an imbalance or improper installation of the rotating components of the compressor (such as the wind turbine), it will generate additional vibration and impact, increase the load on the main bearing, and cause the bearing layer to loosen or fall off.
3. Poor lubrication: Incorrect lubrication or lack of sufficient lubricating oil can increase the friction between the main bearing and the main shaft, thereby exacerbating the wear and detachment of the bearing layer.

The following measures can be taken to address the issue of Babbitt alloy detachment in the spindle tile:
1. Regular inspection and maintenance: Regularly check the condition of the main shaft bearing of the compressor, including wear and tightness of the bearing layer. Timely repair or replace severely worn tile layers, and ensure that the tile layers are firm and reliable.
2. Balance correction: Ensure the balance of all rotating components and perform dynamic balance correction according to the manufacturer's recommendations. This helps to reduce the vibration and impact caused by imbalance, thereby reducing the load on the main bearing.
3. Good lubrication: Regularly check the lubrication system to ensure the quality and sufficient supply of lubricating oil. According to the manufacturer's recommendation, select and use suitable lubricants correctly, and follow the lubrication maintenance plan.
4. Uniform loading: Try to avoid sudden starts or stops, as well as frequent load changes as much as possible. This can reduce the impact and stress on the main bearing and extend its service life.
5. Regular training and management: Train operators on how to correctly operate and maintain compressors, and improve their understanding of compressor performance and safety. At the same time, establish a comprehensive maintenance record and management system, track maintenance work, and promptly address issues.

In summary, measures such as regular inspection and maintenance, balance calibration, good lubrication, uniform loading, and training management can reduce the risk of Babbitt alloy detachment in the compressor main shaft bearing and improve the reliability and service life of the compressor.